Process Selection on the Basis of Time Cost and Quality for Development Components of Aluminium Bracket

Author(s)	Piyush Shukla
Country	India
Abstract	Development of various new processes has reduced the development of tooling while Designing of Aluminium Component before going to mass production by Dies. The selection of the Process to manufacture Proto quality of Aluminium is not significant. In present research is an attempt to prove that Die Casting Die in soft condition die is also recommended process for commissioning quantity of aluminium component because for prototyping one or two quantity are sufficient. Proto DCD process is also Compared with Time, Cost & quality parameters on this basis process can be selected only for maximum one thousand quantity requirement
Keywords	process compared: Soft Die casting die, 3D printing DMLS and VMC machining Material: Aluminium Alsi10mg , Al6061
Field	Engineering
Published In	Volume 6, Issue 4, July-August 2024
Published On	2024-07-21
Cite This	Process Selection on the Basis of Time Cost and Quality for Development Components of Aluminium Bracket - Piyush Shukla - IJFMR Volume 6, Issue 4, July-August 2024. DOI 10.36948/ijfmr.2024.v06i04.23092
DOI	https://doi.org/10.36948/ijfmr.2024.v06i04.23092
Short DOI	https://doi.org/gt43xc

About IJFMR Fees & Payment Current Issue Publication Archive	Submit Research Paper Track Submission Status Publication Guidelines Publication Ethics Peer Review & Plagiarism	Join as a Reviewer Editors & Reviewers Reviewer Referral Program Get Reviewer Membership Certi.	Website/Journal Policies Usage Policy Content Policies Privacy Policy

Contact Us		+91-9898-5948-55	editor@ijfmr.com

International Journal For Multidisciplinary Research